H3c-technologies H3C WA2600 Series WLAN Access Points Uživatelský manuál stáhnout pdf (Strana 22)

5-2

Figure 5-1 Network diagram for PPPoE configuration

Configuring a PPPoE Client

PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.

Configuring a Dialer Interface

Before establishing a PPPoE session, you must first create a dialer interface and configure a dialer

bundle on the interface. Each PPPoE session uniquely corresponds to a dialer bundle and each dialer

bundle uniquely corresponds to a dialer interface. Thus, a PPPoE session uniquely corresponds to a

dialer interface.

Follow these steps to configure a dialer interface:

To do... Use the command... Remarks

Enter system view

system-view

—

Configure a dialer rule

dialer-rule

dialer-group { protocol-name

{

permit

deny

} |

acl

acl-number }

Required

Create a dialer interface

interface dialer

number Required

Create a dialer user

dialer user

username

Required

Assign an IP address to the interface

ip address

{ address mask |

ppp-negotiate

}

Required

Create a dialer bundle on the interface

dialer bundle

bundle-number Required

Create a dialer group on the interface

dialer-group

group-number Required

You can also configure PPP authentication or set other parameters on the dialer interface as needed.

Configuring a PPPoE Session

PPPoE sessions fall into these categories: permanent PPPoE session, packet-triggered PPPoE

session, and diagnostic PPPoE session.

1 2 ... 17 18 19 20 21 22 23 24 25 26

Komentáře k této Příručce

Žádné komentáře

H3c-technologies H3C WA2600 Series WLAN Access Points Uživatelský manuál Strana 22

Komentáře k této Příručce

Související produkty a manuály pro Směrovače H3c-technologies H3C WA2600 Series WLAN Access Points