H3c-technologies H3C SecPath M9000 Series Uživatelský manuál

H3C SecPath M9000 Multi ServiceSecurity Gateway SeriesInstallation Quick Start Hangzhou H3C Technologies Co., Ltd. http://www.h3

7 2. Put on the wrist strap. 3. Tighten the wrist strap to keep good skin contact. 4. Insert the ESD-preventive wrist strap into the ESD port on t

8 Figure 9 Installing a card (1) Insert the card into the slot (2) Press the ejector levers inward (3) Fasten the captive screws Installing a pow

9 Figure 10 Installing a power module in a vertical slot (on an M9010) Figure 11 Installing a power module in a horizontal slot Connecting an AC

10 Figure 12 Securing the AC power cable (on an M9006) Connecting a DC power cable WARNING! • Make sure each power cable has a separate circuit

11 Installing an XFP/SFP+/SFP/QSFP+ transceiver module (optional) 1. Unpack the module. Do not touch the golden finger of the transceiver module. 2.

12 Figure 15 Connecting the console cable NOTE: The serial ports on PCs do not support hot swapping. If the gateway has been powered on, connect

13 Index C G I L O C Confirming installation preparations,1 Connecting a DC power cable,10 Connecting an AC power cable,9 G Grounding the gateway,6

Copyright © 2013, Hangzhou H3C Technologies Co., Ltd. and its licensors All rights reserved No part of this manual may be reproduced or transmitted

i Contents Installation quick start ··················································································································

1 Installation quick start This quick start guide provides basic instructions for installing an M9000 multiservice gateway. For more detailed install

2 Installing cage nuts 1. Align the mounting bracket with the left rack post, making sure the bottom edge and the slide rail or rack shelf are level

3 • The M9010 has two cable management brackets—the signal cable management brackets are installed at the upper part of the gateway, and the power c

4 Figure 4 Attaching cable management brackets to an M9006 (1) Attach the cable management bracket to the chassis (2) Screw holes for installing the

5 Mounting the gateway to the rack CAUTION: Do not hold the handle of the fan tray or power module, or the handle on the rear of the chassis, or t

6 Grounding the gateway CAUTION: • Before you use the gateway, connect the grounding cable properly to guarantee lightning protection and anti-in