H3c-technologies H3C WX5000 Series Access Controllers Uživatelský manuál stáhnout pdf (Strana 38)

4-3

Figure 4-4 HyperTerminal window

Step6 Set HyperTerminal properties. Select File > Properties > Settings in the HyperTerminal to enter the

properties setting window, as shown in Figure 4-5

. Select VT100 as the terminal emulation, and click

OK.

Figure 4-5 Set terminal emulation

Powering On the Access Controller

Checking Before Power-On

Before powering on the access controller, verify that:

z The power cord and the ground wire are properly connected.

z The power supply voltage is within the range that required by the access controller.

z The console cable is properly connected; the terminal (for example, a PC) used for configuration

has been started; the configuration parameters have been set.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 84 85

Žádné komentáře

H3c-technologies H3C WX5000 Series Access Controllers Uživatelský manuál Strana 38