H3c-technologies H3C WX5000 Series Access Controllers Uživatelský manuál stáhnout pdf (Strana 52)

5-12

|Note:the operating device is cfa0 |

|<1> Backup Full BootWare |

|<2> Restore Full BootWare |

|<3> Update BootWare By Serial |

|<4> Update BootWare By Ethernet |

|<0> Exit To Main Menu |

===========================================================================

Enter your choice(0-4):

Enter 0 on the BootWare operation submenu to return to the BootWare main menu:

===========================<EXTEND-BOOTWARE MENU>===========================

|<1> Boot System |

|<2> Enter Serial SubMenu |

|<3> Enter Ethernet SubMenu |

|<4> File Control |

|<5> Modify BootWare Password |

|<6> Skip Current System Configuration |

|<7> BootWare Operation Menu |

|<8> Clear Super Password |

|<9> Storage Device Operation |

|<0> Reboot |

============================================================================

Enter your choice(0-9): 0

Enter 0 on the BootWare main menu to reboot the access controller.

Upgrading the BootWare Through a Serial Interface

Enter the BootWare main menu (refer to section “BootWare Main Menu” on page 5-4). On the BootWare

main menu, enter 7. The system will enter the BootWare operation submenu, where you can perform all

BootWare operations. For detail description on this submenu, refer to section “BootWare operation

submenu

” on page 5-7.

Enter 3 on the BootWare operation submenu to enter the BootWare operation serial submenu:

======================<BOOTWARE OPERATION SERIAL SUB-MENU>======================

|<1> Update Full BootWare |

|<2> Update Extend BootWare |

|<3> Update Basic BootWare |

|<4> Modify Serial Interface Parameter |

|<0> Exit To Main Menu |

================================================================================

Enter your choice(0-4):

Enter 4 on the BootWare operation serial submenu. The system prompts you to modify the baud rate:

=================================<BAUDRATE SET>=================================

|Note:'*'indicates the current baudrate |

| Change The HyperTerminal's Baudrate Accordingly |

|-----------------------------<Baudrate Available>-----------------------------|

|<1> 9600(Default)* |

|<2> 19200 |

|<3> 38400 |

H3c-technologies H3C WX5000 Series Access Controllers Uživatelský manuál Strana 52

Komentáře k této Příručce

H3c-technologies H3C WX5000 Series Access Controllers Uživatelský manuál Strana 52

Komentáře k této Příručce

Související produkty a manuály pro Směrovače H3c-technologies H3C WX5000 Series Access Controllers