H3c-technologies H3C WX6000 Series Access Controllers Uživatelský manuál stáhnout pdf (Strana 565)

100

101

60-7

These hotkeys are defined by the device. When you interact with the device from terminal software,

these keys may be defined to perform other operations. If so, the definition of the terminal software will

dominate.

Configuring User Levels and Command Levels

All the commands are defaulted to different views and categorized into four levels: visit, monitor, system,

and manage, identified respectively by 0 through 3. If you want to acquire a higher privilege, you must

switch to a higher user level, and it requires password to do so for the security’s sake.

The following table describes the default level of the commands.

Table 60-3 Default command levels

Level Privilege Command

0 Visit

ping, tracert, telnet

1 Monitor

refresh, reset, send

2 System All configuration commands except for those at manage level

3 Manage FTP, TFTP, XMODEM, and file system operation commands

Follow these steps to configure user level and command level:

To do… Use the command… Remarks

Switch the user level

super

[ level ]

Optional

Available in user view.

Enter system view system-view —

Configure the password for

switching the user level

super password

[

level

user-level

] {

simple

cipher

}

password

Optional

By default, no password is

configured.

Configure the command level in

system view

command-privilege level

level

view

view command

Optional

The commands available depend on your user level when you log onto a device. For example, if your

user level is 3 and the command level of VTY 0 interface is 1, you can use commands below level 3

(inclusive).

1 2 ... 560 561 562 563 564 565 566 567 568 569 570 ... 677 678

Komentáře k této Příručce

Žádné komentáře

H3c-technologies H3C WX6000 Series Access Controllers Uživatelský manuál Strana 565

Komentáře k této Příručce

Související produkty a manuály pro Směrovače H3c-technologies H3C WX6000 Series Access Controllers