H3c-technologies H3C SecPath F5000-S Firewall Uživatelský manuál stáhnout pdf (Strana 29)

Connecting Ethernet cables

Connecting a copper Ethernet port

You can use either a straight-through or a cross-over network cable. For more information about Ethernet

twisted pair cables, see "Ethernet twisted pair cable."

To connect a copper Ethernet port:

1. Connect one end of the Ethernet cable to the copper Ethernet port of the firewall, and the other end

to the Ethernet port of the peer device.

2. Examine whether the LEDs of the Ethernet port are normal. For more information about LEDs, see

"MPU LEDs."

After you connect the firewall to the network, use the ping or tracert command to examine network

connectivity. For more information, see the related command reference.

Connecting a fiber port

The firewall supports GE SFP transceiver modules and 10GE SFP+ transceiver modules. For the

transceiver module specifications, see "GE fiber Ethernet port" and "10 GE fiber Ethernet port."

No transceiver module is shipped with the firewall. H3C transceiver modules are recommended.

Figure 16 GE SFP transceiver module appearance

Figure 17 10GE SFP+ transceiver module appearance

Connecting an optical fiber

ARNING!

Do not stare into any fiber port when you connect an optical fiber. The laser li

ht emitted from the optical

fiber might hurt your eyes.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 85 86

Žádné komentáře

H3c-technologies H3C SecPath F5000-S Firewall Uživatelský manuál Strana 29