H3c-technologies H3C WX5500E Series Access Controllers Uživatelský manuál stáhnout pdf (Strana 200)

189

Figure 58 Setting the state of each member port in a service loopback group

Each time a new port is assigned to the service loopback group, the system sets the state of all the

member ports all over again.

Configuration procedure

When you configure a service loopback group, follow these restrictions and guidelines:

• Make sure the ports you are assigning to a service loopback group meet the following

requirements:

Item Re

uirements

Link type Access.

Aggregation membership

The ports are not members of link aggregation groups or any other service

loopback group.

Support for services The ports support the service type of the service loopback group.

Feature compatibility

The following features are not configured on the ports:

• 802.1X

• Isolate-user-VLAN

• MAC authentication

• MSTP

• NDP

• Port security

• Uplink/downlink ports of a port isolation group

NOTE:

On service loopback group member ports, you can only configure port attributes

(including port rate and duplex mode), ACL, and QoS.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 220 221

Žádné komentáře

H3c-technologies H3C WX5500E Series Access Controllers Uživatelský manuál Strana 200