H3c-technologies H3C WX5500E Series Access Controllers Uživatelský manuál stáhnout pdf (Strana 58)

Layer 2 dynamic aggregation configuration example

Network requirements

As shown in Figure 11:

• Configure a Layer 2 dynamic aggregation group on Device A and Device B. Enable VLAN 10 at

one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one

end to communicate with VLAN 20 at the other end.

• Enable traffic to be load-shared across aggregation group member ports based on source and

destination MAC addresses.

Figure 11 Network diagram

Configuration procedure

1. Configure Device A:

# Create VLAN 10, and assign the port GigabitEthernet 1/0/4 to VLAN 10.

<DeviceA> system-view

[DeviceA] vlan 10

[DeviceA-vlan10] port gigabitethernet 1/0/4

[DeviceA-vlan10] quit

# Create VLAN 20, and assign the port GigabitEthernet 1/0/5 to VLAN 20.

[DeviceA] vlan 20

[DeviceA-vlan20] port gigabitethernet 1/0/5

[DeviceA-vlan20] quit

# Create Layer 2 aggregate interface Bridge-Aggregation 1, and configure the link aggregation

mode as dynamic.

[DeviceA] interface bridge-aggregation 1

[DeviceA-Bridge-Aggregation1] link-aggregation mode dynamic

# Assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to link aggregation group

1 one at a time.

[DeviceA] interface gigabitethernet 1/0/1

[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1

[DeviceA-GigabitEthernet1/0/1] quit

[DeviceA] interface gigabitethernet 1/0/2

[DeviceA-GigabitEthernet1/0/2] port link-aggregation group 1

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 220 221

Žádné komentáře

H3c-technologies H3C WX5500E Series Access Controllers Uživatelský manuál Strana 58